CP40 Conductivity Probe 300mm long x 3/8" BSP
CP40 Conductivity Probe
300mm long x 3/8" BSP
The Spirax Sarco CP40 conductivity probe is used in conjunction with a controller to measure the conductivity (or TDS) of water, usually in a steam boiler for the purpose of monitoring and controlling blowdown.
The probe may be installed in a Spirax Sarco probe elbow, a screwed flange, or directly in a boiler connection. The CP40 is supplied in four nominal tip lengths, and is cut to the exact length required prior to installation.
A DIN 43650 cable socket with Pg 11 cable gland is supplied with the unit.
- Features
- Conductivity probe for use with blowdown controllers.
- Suitable for use in steam boilers up to 32 bar g, 239 °C.
- All wetted parts in austenitic stainless steel/PTFE.
- Easily cut to length.
Pressure/Temperature Limits
Nominal pressure rating | PN40 | |
---|---|---|
Maximum boiler pressure | 32 bar g | (464 psi g) |
Maximum operating temperature | 239°C | (462°F) |
Maximum ambient temperature | 70°C | (158°F) |
Designed for a maximum cold hydraulic test pressure of: | 60 bar g | (870 psi g) |
Technical Data
Minimum distance from boiler tubes | 20mm | 3/4" |
---|---|---|
Minimum immersion depth (Vertically installed probes) | 100mm | 4" |
Maximum cable length (probe to controller) | See controller IMI | |
Minimum conductivity | 10 μS/cm or 5 ppm | |
Degree of protection | IP54 |
CP40 Conductivity Probe
300mm long x 3/8" BSP
The Spirax Sarco CP40 conductivity probe is used in conjunction with a controller to measure the conductivity (or TDS) of water, usually in a steam boiler for the purpose of monitoring and controlling blowdown.
The probe may be installed in a Spirax Sarco probe elbow, a screwed flange, or directly in a boiler connection. The CP40 is supplied in four nominal tip lengths, and is cut to the exact length required prior to installation.
A DIN 43650 cable socket with Pg 11 cable gland is supplied with the unit.
- Features
- Conductivity probe for use with blowdown controllers.
- Suitable for use in steam boilers up to 32 bar g, 239 °C.
- All wetted parts in austenitic stainless steel/PTFE.
- Easily cut to length.
Pressure/Temperature Limits
Nominal pressure rating | PN40 | |
---|---|---|
Maximum boiler pressure | 32 bar g | (464 psi g) |
Maximum operating temperature | 239°C | (462°F) |
Maximum ambient temperature | 70°C | (158°F) |
Designed for a maximum cold hydraulic test pressure of: | 60 bar g | (870 psi g) |
Technical Data
Minimum distance from boiler tubes | 20mm | 3/4" |
---|---|---|
Minimum immersion depth (Vertically installed probes) | 100mm | 4" |
Maximum cable length (probe to controller) | See controller IMI | |
Minimum conductivity | 10 μS/cm or 5 ppm | |
Degree of protection | IP54 |
Datasheets |
---|