Jet Blue Plus Jointing Compound 500g Tub
Product Characteristic
Service Range | -18°c to 120°c after application |
---|---|
Fluid Type | Vegetable Oil |
Colour Appearance | Beige semi fluid |
Specific Gravity | 1.32 |
Oil Separation Wr. % Loss @ 100°C (212°F) |
Not applicable |
Flash Point (Seta Closed Cup) | 113°C |
Non-volatile Content | >85% |
Viscosity, Brookfield (ASTM D-2196) 25oC | 120,000-180,000 cPs |
Copper Strip Corrosion (ASTM D-4048) | 1A |
Directives & Standards Compliance
• BS 6920-1:2000 and/or 2014 Suitability of non-metallic products for use in contact with water intended for human consumption with regards to their effect on the quality of the water
• BS EN 751-2: 1997 Class arp and class b thread sealant as defined by for gas pipe connections
- Note :
- Do not use Jet Blue Plus on abs or cpvc
- Do not re-use fittings as they are often deformed and may not seal effectively
- Make sure the fittings are round and not oval
- WRAS regulations do not allow the use of hemp fibres with V-2 Plus
- Coat the sealant onto the male threads
- Tighten according to the applicable standard
- Certain applications may require a delay for optimum results
Jet Blue Plus Jointing Compound 500g Tub
Jet Blue Plus multi-purpose jointing compound is a soft-setting, non-petroleum based thread sealant for use with potable water, liquids and gases, where immediate pressurisation is necessary.
Jet Blue Plus is easily applied with a brush (not included) and will provide an excellent seal for correctly made-up taper thread connections to 50mm (2”) diameter.
Apply using an even coating to the male thread, the joint can be loosened and re-tightened to adjust the final pipework installation. Pipe jointing compound jet blue may be used on steel, aluminium, brass, copper, iron, Polyethylene, reinforced fibreglass and pvc.
- Features
- Suitable for gas installation work carried out by Corgi registered personnel
- WRAS approved for use with cold (potable water)
- Suitable for hot water up to 120°C
- Suitable to use on steel, aluminium brass, copper, iron, Polyethylene, reinforced fibreglass, and PVC
- Suitable for a threaded pipe carrying air, water, brine, water/glycol mix, natural gas, butane/propane gas, Co2 gas, refrigerants, hydraulic oil, inert gas, dilute acid/alkali & steam at low pressure
- Soft setting
- Allows immediate pressurisation (certain applications may require a delay for optimum results)
- Not petroleum based
- Water resistant
- Contains aramid fibre, PTFE & natural fillers
- Corgi approved for gas installation
- Lead & other metal free
- Low odour
- Contains aramid fibre, PTFE & natural filters
- Brushable to -18°C
Datasheets |
---|