DOC Pumps are a versatile, corrosion resistant, sbmersible electric pump designed to be used in dirty and Unclean Water. Different versions are availale with 0.3 to 0.7kW motor powers. A DOC 7X version with Vortex Impeller is also available.
All Pump Types
- Maximum liquid temperature 40°C with partially submerged pump.
- Dry Motor
- Maximum immersion depth 5m
- Class B insulation
- Single Phase
- Input Power : 240V / 50Hz
DOC 3 Pump Specification
- Capacity of 145 l/min
- Head up to 7m
- Passes suspended solids up to 10mm in Diameter
DOC 7 Pump Specification
- Capacity of 230 l/min
- Head up to 11m
- Passes suspended solids up to 10mm in Diameter
DOC 7VX Specification
- Capacity of 180 l/min
- Head up to 7m
- Passes suspended solids up to 20mm in Diameter
- A shallow suction device can be mounted to both the DOC 3 & DOC 7 models is available on request. It ensures complete drainage of flooded floors, up to 3mm from the floor.
- Single Phase : 220V, 50Hz, 2 Poles (2850rpm)
- Pre-Assembled Float : For automatic pump operation (available without float on request)
- Built in Capacitor
- Thermal Overload Protection : To stop pump supply in case of everything.
Lab-Lip Seal
The electric motor is protected by three lip seals.
An impeller counterblade system keeps solid particles away from the seal unit to prevent damage to the lip seals and ensure their long-lasting efficiency. A double labyrinth and a V-Ring on the shaft have also been provided.
The electric motor is protected by three lip seals.
An impeller counterblade system keeps solid particles away from the seal unit to prevent damage to the lip seals and ensure their long-lasting efficiency. A double labyrinth and a V-Ring on the shaft have also been provided.
Float Switch Design
This float switch allows the pump to be used where the standard float design cannot work due to insufficient space. The pump with this system can only be installed vertically and can only be used with clean water.
For pump installations that use the tube float switch, the level of start and stop are fixed therefore they cannot be modified.
This float switch allows the pump to be used where the standard float design cannot work due to insufficient space. The pump with this system can only be installed vertically and can only be used with clean water.
For pump installations that use the tube float switch, the level of start and stop are fixed therefore they cannot be modified.
Table of Materials
| Part | Materials |
|
Noryl Technopolymer |
|
Stainless Steel (AISI 304 - DIN 1.4301) |
|
Stainless Steel (AISI 416 - DIN 1.4005) |
|
Nitrile Rubber (NBR) |
